Site Logo

Free UK Shipping Over £25

Site Logo

Fantastic Brands

Site Logo

Over 30 Years Experience

Site Logo

Practical, Affordable

Site Logo

Like our social pages!


ObsidianWire LP Custom SC 60s  (Split Coil) for Les Paul®

ObsidianWire LP Custom SC 60s (Split Coil) for Les Paul®



£99.00

Humbuckers to Singlecoils and Back Again

Coil Tap Wiring for Les Paul®

Split your humbuckers into single coils for classic, low output spank, and back again with a tap of the volume control.   

A pop in replacement for your Gibson® Les Paul® wiring harness.

The ObsidianWire Custom SC is a Split Coil / Coil Tap upgrade wiring harness for your Les Paul®. The upgrade uses premium CTS push / Pull pots for ultimate tonal flexibility, and saves you a whole lot of work by making the install super easy and 100% solder-less.

(requires 4 conductor pickups)

ObsidianWire SC Switching

Split your humbucker pickups into single coils, allowing for Strat® or Tele® like tones, and back again with a push or pull of the volume control.

Each pickup has its own switch, so you can split each one on its own, or both at the same time.

 

Both Switches Down (Traditional LP)

Position 1: Bridge Humbucker
Position 2: Bridge Humbucker + Neck Humbucker
Position3: Neck Humbucker

Both Switches Up

Position 1: Bridge Single Coil
Position 2: Bridge Single Coil + Neck Single Coil
Position3: Neck Single Coil

Neck Volume Switch Up - Bridge Volume Switch Down

Position 1: Bridge Humbucker
Position 2: Bridge Humbucker + Neck Single Coil
Position3: Neck Single Coil

Neck Volume Switch Down + Bridge Volume Switch Up

Position 1: Bridge Single Coil
Position 2: Bridge Single Coil + Neck Humbucker
Position3: Neck Humbucker

ObsidianWire 60s - Cut Through at Any Volume

The ObsidianWire 60s wiring retains treble when you roll back the volume control allowing you to retain your overall tone and cut through at lower volumes. The controls are more intuitive with the 60s set, with the tone control changing tone and the volume control changing the volume.

World’s Best Craftsmanship and Components

  • Premium Selected CTS Split Shaft Pots 500k (+/-8%) (Matched to +/-2%)
  • Premium Selected CTS Split Shaft Push / Pull Pots 500k (+/-8%) (Matched to +/-2%)
  • Obsidian Select Long Life Enclosed Toggle Switch
  • Obsidian Select Capacitors (150 Series Polyester Film 0.022uf) (Hand Tested to +/-10%)
  • Genuine Switchcraft J11 Mono Output jack
  • Pre Printed & Easy to Follow Wiring Diagram
  • Endless Customer Support

Compatibility

Requires 4 conductor pickups - Will work without split coil capability with regular two conductor pickups.

American Series Gibson® Les Paul® - Direct Fit

Epiphone® Les Paul® - You will need to widen the control holes out to 10mm and get new US Spec, 24 spline knobs to fit the higher grade electronics.

Other Models - We cannot guarantee that these will fit any other guitar.

CLICK HERE FOR MORE INFO

Reviews

Write a customer review and share your thoughts with other customers.

Peter Llewellyn - Oban 4 Stars

Great product but difficult to fit to my Epiphone LP

Great product and very prompt dispatch, however the Obsidianwire harness does NOT fit all Epiphone Les Paul models (easily anyway...).

I fitted this to an Epiphone Standard Plus Top Pro from about 2015. After 5 hours of tricky work I managed to squeeze it in, the switch cavity needed to be enlarged to fit the wider switch, the main cavity needed to be enlarged in several places, including to allow the pickup and switch wires to enter the cavity and the holes for the knobs as well as needing widening were misaligned. If you are not confident with doing some quite major surgery to the woodwork of your guitar I would think twice about installing this harness.

HOWEVER it does sound AMAZING, it has completely transformed the sound of the guitar, the volume knobs are actually useable (rather than virtually no difference between 2 and 8 on the old ones) and the tone is hugely improved with way more treble and clarity. Also any future pickup changes will be a doddle with the solderless connectors.

A fully dimensions diagram of the harness and switch would be very useful to check how easily it will fit.

Jehanne - Derbys 5 Stars

Obsidian 60s Les Paul

Just installed the Obsidian into my Les Paul, and as well as being easy to install it has given a much clearer tone and cut compared to the stock PCB board that was fitted to my 2017 Les Paul Standard. I like to play around with pickups but i dont like the fuss and time it takes when you have to solder them and mess. So this is just perfect for me! Thanks to the guys at El Toro for supplying my Obsidian with speedy delivery and a brilliant service! I can recommend you give one a try if your thinking about it!

You will earn 99 points which is the equivalent of £0.99
Site Logo